Defenderworx H2 INTERIOR TRIM RINGS User Manual download pdf

H2PDC05103 / H2PPC05103 INTERIOR TRIM RINGS

INSTALLATION INSTRUCTIONS

There are three different sizes of rings in the kit. The three large thick rings go in the following

positions: driver left vent, two center vents. The one large thin ring goes on the passenger side

vent. The two small rings go on the back side of the center console.

Rings are supplied with double backed automotive adhesive strips. The correct side of the tape is

important. The white side goes against the rings and the brownish side goes toward the vehicle’s

surface. Lay out the rings and determine the placement of the adhesive and be sure that they will

fit the rings. There can be 3-5 pieces for each ring. The adhesive will straddle the inside radius and

should be placed so that the adhesive is not visible when in place. Once you have determined

where you are going to put them it is time to peel and stick. Peel off the white side and place the

adhesive on the parts, firmly pressing it to conform to the inside shape of the rings.

If your rings have decorative dimples it is important to place them on each vent with the correct

orientation so that they all match. Once that decision is made, then peel off the brownish adhesive

cover and place the vent in position, be sure it is centered directly on the vent before pressing into

place. Apply firm even pressure around the ring to set it into place.

Defenderworx, Inc.

1120 North Armando Avenue

Anaheim, CA 92806

(714) 630-9700 Phone

(714) 630-9701 FAX

www.defenderworx.com

H2PDC05103 / H2PPC05103 INTERIOR TRIM RINGS INSTALLATION INSTRUCTIONS There are three different sizes of rings in the kit. The three large thick r

No comments

Defenderworx H2 INTERIOR TRIM RINGS User Manual